Archive for the ‘K&K Trinity Pre Amp’ Category

Zofia Pedalboard to use with K&K Trinity Pickup System

September 11, 2014

This is my pedalboard to primarily use with my Zofia Cedar Blanca equipped with a K&K Trinity Pickup. The pedals are mounted on a PedalTrain JR board, I’m using a Decibel 11 HC Power supply to power all pedals except the BBE Acoustimax. I also have jacks and parts from The Pedalboard Shop. So from the guitar out jack the cable comes into a input jack TRS supplied from (The Pedal Shop) to the K&K Trinity System 2 Channel Preamp, to BBE Acoustimax. On the BBE I use the effects loop to run 1, TC Electronics Spark, 2, Neunaber Wet Stereo Reverb, 3, DigiTech Jam Man Stereo (in that order) then DigiTech back to BBE to close the effects loop. I also use from the BBE tuner out a TC Electronic PolyTune mini. I will be adding a wireless system and a compressor soon as well as the Beat Buddy when it finally ships.

IMG_1489-1.JPG

IMG_1487-1.JPG

IMG_1462-1.JPG

IMG_1430-1.PNG

IMG_1429-0.PNG

Advertisements

Live Setup Update

August 11, 2014

For most of my playing where I don’t have to go too loud I will be using my JDZ Blanca with K&K Trinity Pickups, to the K&K Trinity Preamp, BBE Acoustimax (use the effects loop to connect to), TC Electronic Spark, NT Neunaber WET Reverb, DigiTech Stereo Looper out to Bose Tone Match Mixer and Bose L1S System. That’s it

IMG_4153.JPG

IMG_1379.JPG

IMG_1376.JPG

Pedal Board for use with K&K Trinity Pickups

August 3, 2014

Pedal Board Mini Completed,
K&K Trinity System 2 Chanel Preamp using AC power (not 9v battery), TC Electronic Spark, NT Neunaber Technology Wet Stereo Reverb, Digitech Jam Man Stereo and out to the Bose Tone Match and L1S, System is getting smaller.

20140803-173641-63401590.jpg

K&K Trinity and Trinity Preamp System Set Up for Zofia Blanca

August 2, 2014

Just reset the gain and eq settings in my K&K Trinity Preamp. I have the pickup at 80% gain 85% treble flat mid cut 8:00 and bass flat mic at 50% gain treble flat, mid cut 9:00, bass 10:00. Into my Bose L1S with Tone Match preset 80Hz Highpass all eq on Bose is flat and no Q. No compression and just 35 hall reverb. I wish some one would make a two channel guitar preamp that has two 5 band eq with sweepable mids on both a Highpass filter, phantom power on 1 mic Chanel, phase, effects loop, aux in 1/8 for iPod (battery or 48v) phantom power and small engulf to clip on to a guitar strap. Headway EB2 came so close but only really one channel can be eq. I know you can assign it to both but I like to eq the bass on pickups differently than the mic or sensor in guitar. I’m very happy with my Zofia Cedar Blanca and working with Jorge was an absolute pleasure, if your in the area next Sunday I will playing this guitar at Unionville Winery in Ringos NJ as they release Foxy Lady.

>
20140802-172515-62715644.jpg

20140802-172646-62806854.jpg

20140802-172516-62716231.jpg

20140802-172515-62715960.jpg<br /